Operation By Remote Control - Ibiza Light LED-CUBE2020 Manual De Uso

Operation by Remote Control

NOTE: First remove the small plastic sheet from the battery cover before operation
1.
Brightness intensity and speed button: Adjust the speed when in smooth modes.
Change brightness intensity when the light is fixed on one single color.
2.
ON/OFF button: Press this button to turn on and turn off the light. This button only
controls the light but not the Bluetooth function. If the unit is charged, the last set
mode is kept in memory and the cube will be set on the last set mode. If the battery is
exhausted, the default mode is SMOOTH.
3.
Bluetooth ON/OFF button: Press this button to turn on and turn off the Bluetooth
function. After one press, the Bluetooth function is activated. The Bluetooth indicator
light will start flashing in blue and a voice says "POWER ON". Activate the Bluetooth function on your mobile
phone to pair it with the "color cube BT". Once the Bluetooth is connected to your mobile phone, the Bluetooth
indicator will light up steadily in blue and the voice says "SPEAKER CONNECTED".
If you leave the range of 10m around the cube, the Bluetooth indicator will flash in blue and a voice says
"SPEAKER DISCONNECTED". If you go back into a range of 10m, the Bluetooth indicator glows steadily blue and
the voice says "SPEAKER CONNECTED".
The Bluetooth indicator light is inside the cube below the speaker. The Bluetooth indicator light goes off when the
Bluetooth is off.
Once the Bluetooth is connected, press the button again to disconnect the Bluetooth.
Only one mobile phone can be paired at the same time with the LED-CUBE.
4.
Color selection button: When the light is on, press this button to choose your favorite color as shown on remote
control (Six colors)
5. +
White warm button: press to increase the warmth in 7 steps.
6. -
White warm button: press to reduce the warmth in 7 steps.
7.
Color selection button: When the light is on, press this button to choose your favorite colors (Total 7 colors)
8. The light will flash automatically to the rhythm of the music.
9. 7 colors scroll automatically
10. When you switch the unit on, the timer function is disabled and the light works normally.
If you press the button once, the unit lights up in RED during 30 minutes and switches off the light and the
Bluetooth function.
If you press the button twice, the light will light GREEN during 30 minutes. Then, the light and the Bluetooth
function will switch off.
If you press the button 3 times the light will light DARKBLUE during 30 minutes. Then, the light and the Bluetooth
function will switch off.
If you press the button 4 times the light will light YELLOW during 30 minutes. Then, the light and the Bluetooth
function will switch off.
If you press the button 5 times the light will light BLUE during 150 minutes. Then, the light and the Bluetooth
function will switch off.
©Copyright LOTRONIC 2015 LED-CUBE Manual 3