Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Your Universal TV Remote controls most all TV brands
presently available.
Battery Saver:
If the remote accidentally gets stuck down the back of
the couch with a button pressed it will stop transmitting
after about 30 seconds so as not to drain the battery.
Code Saver:
When changing batteries have the new batteries handy
before removing the old ones. If the remote has no bat-
teries installed for more than about 10 minutes you will
lose the installed code.
Setup Instructions
1. Install 2 AAA alkaline batteries in the battery com-
partment on the back of the remote.
2. Look up the 4-digit code for your brand of TV from
the Code Table and install it into the remote.
Direct Library Code Entry
To enter Codes directly from Library Code Table:
1. Press and Hold the Power and Mute buttons simulta-
neously until the red indicator remains on.
2. Release the buttons.
3. Enter the 4-digit Code from the Code List (on page
8) using the CH-, V-, CH+ and V+ buttons. The CH-
button is used for entering the first digit. V- button is
used for entering the second digit. CH+ is used for
entering the third digit and V+ is used for entering
the fourth digit. E.g., for code 0107, do not press
CH-, press V- once, do not press CH+, and finally
press V+ seven times.
4. Press the Mute button to save the code. Note: for a
valid code, the red indicator turns off. For an invalid
code, the red indicator blinks rapidly for three sec-
onds before going off.
5. Direct code entry is now complete.
6. Write your code below in case you forget it:
2
Publicidad
