Hitachi RAS-25CNH2 Manual De Instrucciones página 17

ATTACHING THE AIR CLEANSING AND DEODORIZING FILTERS
Before installation, be sure to stop the operation by using the remote controller.
1
Open the front panel.
G Pull up the front panel by holding it at both sides
with both hands.
2
Remove the filter.
G Push the filter upward to release the claws and
pull out the filter.
3
Attaching the air cleansing and deodorizing filters
to the filter.
G Attach the air cleansing and deodorizing filters to
the frame by gently compress its both sides and
release after insertion into filter frame.
! CAUTION
Do not bend the air cleansing
and deodorizing filter as it may
cause damage to the structure.
4
Attach the filters.
G Attach the filters by ensuring that the surface written
"FRONT" is facing front.
G After attaching the filters, push the front panel at
three arrow portion as shown in figure and close it.
NOTE
G In case of removing the air cleansing and deodorizing filters, please follow the above procedures.
G The cooling capacity is slightly weakened and the cooling speed becomes slower when the air cleansing
and deodorizing filters are used. So, set the fan speed to "HIGH" when using it in this condition.
G
Air cleansing and deodorizing filters are washable and reusable up to 20 times by using vacuum cleaner
or water rinse under running tap water. Type number for this air cleansing filter is <SPX-CFH5>. Please
use this number for ordering when you want to renew it.
G Do not operate the air conditioner without filter. Dust may enter the air conditioner and fault may occur.
Front panel
Front cover
Frame
Make sure the "FRONT" is facing back side
– 17 –
Air filter
Claws
Claws (8 places)