Uline H-7815 Instrucciones De Ensamble página 3

ASSEMBLING CABINET
1. Place the two back panels (1) on a protected
surface. The bottom flange should be facing
upward. Bolt panels together using 7 bolts and nuts.
(Nuts on the inside of the unit). (See Figure 1)
Figure 1
BOTTOM
NOTE: When bolting the unit together, leave
the bolts slightly loose until step 7, unless
otherwise specified.
2. Attach the left side (3) to the back by placing flange
around the back and bolting the back and sides
together. Be sure that the shelf supports on all shelf
adjustment strips point up on both back and side.
(See Figure 2)
Figure 2
PAGE 3 OF 15
ASSEMBLY INSTRUCTIONS
1
TOP
3
1
3. Attach the top (4) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the top over the side panel. The threaded studs
should go through the holes in the top flange of the
side and fasten with 3 nuts. Attach the back to the
top using 4 bolts and nuts. (See Figure 3)
Figure 3
3
Threaded studs
go through the
holes in the
flange at the
top of the side.
4. Attach right side (2) in the same manner used in
Step 2. Make sure the side flange overlaps the
back panel and the flange on the top is over the
right side. Push the side panel up so the studs in the
top go through the holes in the top flange of the
side. Fasten with 3 nuts. (See Figure 4)
Figure 4
3
1
4
1
2
1120 IH-7815