Uline H-9014 Manual Del Usuario página 2

2. Place tabletop face down on non-marring surface,
so the pre-drilled holes face up. Align holes on
plastic mount plate with pre-drilled holes on
tabletop and insert six M6 x 20 mm bolts (2) to
attach. Insert three M6 x 15 mm bolts (3) to attach
the height adjustment lever to underside of tabletop.
(See Figure 2)
M6 x 20 mm
Bolt
M6 x 15 mm
Bolt
Figure 2
3. Align holes on lower shelf with pre-drilled holes on
underside of tabletop and insert four M6 x 12 mm
bolts (4) to attach. Lip on shelf indicates back side of
shelf. (See Figure 3)
Figure 3
PAGE 2 OF 6
ASSEMBLY CONTINUED
Height Adjustment
Lever
M6 x 12 mm Bolt
Lower Shelf
1-800-295-5510
uline.com
4. Turn the base upside down and place it on the
bottom of the center post. Match the three holes
on the bottom of the base with the three holes in
the center post. Use three M6 x 15 mm bolts (3) and
three 7 mm locking washers (5) to secure base to
center post. Fully tighten using 5 mm Allen wrench.
(See Figure 4)
Figure 4
5. Attach locking casters on the long legs of the base
using one 8 mm locking washer (6) and one 8
mm washer (7) per caster. Repeat to attach swivel
casters on the short legs of the base. Fully tighten
with included wrench. (See Figure 5)
Figure 5
Locking
Caster
6. Desk is now fully assembled. Using two people,
carefully flip the desk onto the casters.
M6 x 15 mm Bolt
7 mm Locking
Washer
Swivel
Caster
8 mm Locking
Washer
8 mm
Washer
0221 IH-9014