Adjustments - Bosch T1B Instrucciones De Funcionamiento Y Seguridad

2610001768_T1B 8/17/17 8:57 AM Page 10
BRACKET ADJUSTMENT SCREW
See Figure 10.
Mounting brackets are designed to fit snugly over the
stand rails. When the locking knobs are tightened to
their locked position, you should not be able to remove
the saw and bracket assembly from the rails. If the saw
and bracket assembly can be removed from the rails
when locked, the bracket adjustment screws need to
be tightened. If the saw and bracket assembly will not
fit over both rails, the bracket adjustment screws needs
to be loosened.
NOTE: The saw should be removed from the mounting
brackets before attempting to tighten or loosen the
bracket adjustment screws.
To adjust:
1. Use a wrench (1) to slightly loosen the nut (2).
2. Turn the screw (3) with a phillips screwdriver (4).
Rotate clockwise if the bracket assembly needs to
be tightened or counterclockwise if the assembly
needs to be loosened.
3. Install the bracket on the miter stand rails and
lower the locking lever to check the adjustment.
4. When the correct position is achieved, wrench
tighten the nut to secure.
5. Repeat with the second mounting bracket.
See Figure 11.
The stand is equipped with an adjustable foot for
leveling the stand.
To adjust: loosen wing nut (1) and adjust the height of
the foot (2) by screwing the threaded shaft clockwise to
raise foot or counter-clockwise to lower foot. Retighten
wing nut securely.
level before operating the saw. Choose a level area
to set-up the stand and adjust the adjustable foot so
that all four legs are touching the ground.

Adjustments

TO LEVEL STAND
To reduce the risk of injury,
ensure the stand is stable and
2
3
FIG. 11
10
1
4
FIG. 10
1
2