Wall And Stand Pipe Mounting Bracket; Installation Of Additional Electronics; Installation Control - Endress+Hauser RIA 261 Manual De Instrucciones

4 Mechanical installation
"
34
•
Following the drilling plan, drill and prepare (rawl plugs etc.)
the two mounting holes in the wall.
•
Loosen and remove the unit lid.
•
Mount the unit to the wall using the respective screws, bolts.

4.2.2 Wall and stand pipe mounting bracket

(Option no. 510 03502).
ƒig. 3: Wall and stand pipe mounting bracket
Follow these instructions when using the combined wall/stand
pipe mounting bracket:
•
For wall mounting follow the drilling plan and drill and
prepare the four holes in the wall (rawl plugs, etc.).
•
Install the mounting bracket (B) to the wall or stand pipe
using the materials supplied (A).
•
Loosen and remove the unit lid.
•
Fix the unit to the bracket using two screws.
4.2.3 Installation of additional measurement electronics
Behind the hinged electronics there is room in the housing for
additional measurement electronics, e.g. temperature head
transmitter.
Attention: Always take note of the manufacturers insatallation
and connection instructions of individual manufacturers!

4.3 Installation control

The unit fulfils all requirements accorcding to IP66 NEMA 4x. In
order to retain this protection class after installation or a service
call, the following points must be complied with:
Digital field display