Uline H-7614 Manual Del Usuario

H-7614, H-7615
DOCK SAFETY GATES
TOOLS NEEDED
1/2" Diameter
Hammer
Masonry Drill Bit
Safety Rail x 1
1. Verify the product is positioned in the desired
location. Mark the floor where holes will be drilled
for mounting socket.
WARNING! Wear eye protection when
completing step 2.
NOTE: Make note of which side mounting
socket is being anchored. Gate can be
mounted for either left or right opening.
2. Using a 1/2" diameter
masonry drill bit, drill
a hole approximately
3" deep into the floor.
(See Figure 1)
NOTE: For the
anchor to function
properly, the hole
must be smaller in
diameter than the
anchor bolt.
3. Clean out debris and dust from inside the hole. Fully
insert the anchor bolt through the mounting socket
baseplate and into the hole.
PAGE 1 OF 6
1-800-295-5510
uline.com
18 mm Wrench
Mounting Socket x 1 Foot Plate x 1
INSTALLATION
Figure 1
Eye Protection
PARTS
Caster Kit x 1
4. Slightly tap down the anchor bolt with a hammer if
needed. Slide washer onto anchor bolt. Tighten the
18 mm hex nut until the anchor bolt is secure.
5. Repeat for remaining anchors.
6. Place one end of
safety rail into
mounting socket.
(See Figure 2)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Anchor x 8 U-Bolt x 1
Figure 2
0920 IH-7614