Glacier bay 2190SSHD Guía De Uso Y Cuidado página 6

Installation (continued)
3
Connecting the two tubes
□
□ Place the tapered end of the tube (B) with the two
shelves (D, E) on it into the untapered end of the other
tube (B) with the shelves (D) on it.
4
Connecting the tapered tube to the
twist tube
noTe: If the twist tube (C) does not extend, loosen the
tubes by twisting the tubes in the opposite direction until
the tubes slide up and down freely.
□ Place the large end cap (CC) on the twist tube (C).
□ Insert the tapered end of the long tapered tube (B) into the
top of the twist tube (C).
5
Connecting the short tube to the top
shelf assembly
noTe: If the assembly will be installed on a tub ledge,
first place the tube assembly on the tub ledge and measure
the distance between the top tube and the ceiling.
noTe: If this distance is greater than 16 in., refer to the
Troubleshooting section at the end of this manual.
□ Place the tapered end of the short tapered tube (A) into the
untapered end of the upper tube assembly.
□ Place the small end cap (BB) on the short tapered tube (A).
D
E
D
D
top of twist tube (C)
BB
A
6
top shelf assembly
tapered end
bottom shelf assembly
B
B
bottom shelf assembly
C
CC
top shelf assembly