BOCCHI ETNA 114 Serie Instrucciones De Instalación página 3

Counter Installations
1. Unpack the sink and inspect for defects. If you have any questions, contact BOCCHI immediately toll-free at
877-565-2221 or email BOCCHI directly at info@bocchiusa.com
2. Find the matching dimensions on the spec drawing. If you do not have
a printed copy of your spec drawing, copies can be found online at
www.BOCCHIUSA.com
3. Place the vessel on the counter in the desired spot.
NOTE: Be sure to consider the proper placement in relation to the position of the
faucet so that the drain is in the necessary position.
4. Mark the drain hole of the vessel on the counter while in proper position.
NOTE: You can make additional marks around the base, where
the vessel sits on the counter, if you would like to use it as an
additional guide to placing the vessel back into place after
applying the sealant as instructed below.
6. Cut out a hole using the 120 mm (4.72 inches) diameter circle.
7. Install the drain to the vessel.
NOTE: Follow the instructions provided with the drain you are installing to complete this step.
9. Place the vessel over the counter lining up the drain with the previously cut hole.
Be careful to set the vessel down in the desired orientation and press firmly to
even out the sealant.
www.BOCCHIUSA.com
5. Remove the vessel from the counter. Mark a 120 mm (4.72 inches)circle using the
center of the drain hole previously drawn circle using the same center point.
8. Carefully turn the vessel upside down and apply a thin strip of sealant to the
underside portion of the vessel that will sit directly on the counter when in the
finished position.
10. Remove the excess sealant around the base of the vessel for a clean finish. To
create a strong bond do not move or bump the vessel for at least 24 hours to
allow the sealant to properly set.
optional
3