BOCCHI 1007 Serie Instrucciones De Instalación página 5

2. Semi-Recessed or Drop-In Counter Installation
5. Cut out the opening using a jig saw or similar tool.
6. Check for a perfect fit.
NOTE: Steps 7 & 8 below may be reversed from the order shown based on your personal preference. In some
cases it is easier to install the faucet and drain prior to setting the sink in the finished position. If you prefer
this order, you may reverse these next two steps.
7. Remove the sink and add a dab of silicone to the underside of
each corner of the sink and place it into position over the cutout.
Remove any excess sealant from around the base of the sink for a
clean finish.
8. Install the drain and faucet according to their instructions.
9. To create a strong bond do not move or bump the sink for at
least 24 hours to allow the sealant to properly set.
www.BOCCHIUSA.com
5