Metabo HPT FDV 16VB2 Manual De Instrucciones página 10

English
9. Check the rotational direction (Fig. 5)
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of the
push button.
The L-side of the push button is pushed to
turn the bit counterclockwise.
CAUTION:
● Never change the direction of bit rotation while operating. Turn the power switch
OFF before changing the direction of bit rotation: otherwise, burning of the motor
will result.
● Always use the hammer drill with clockwise rotation, when using it as an hammer
drill.
10. IMPACT to ROTATION changeover (Fig. 6)
The Hammer Drill can be switched
from IMPACT (impact plus rotation) to
ROTATION (rotation only) by rotating
the change lever (Fig. 1). When boring
concrete, stone, tile or similar materials,
sliding the change lever to IMPACT side.
The drill head impacts against the material
while continuing to rotate.
When boring metal, wood or plastic or
tightening, sliding the change lever to
ROTATION side. The drill rotates as an
ordinary electric drill.
CAUTION:
Do not use the Hammer Drill in the IMPACT function if the material can be bored by
rotation only. Such action will not only reduce drill effi ciency, but may also damage
the drill tip.
10
mark
Push Button
mark
Fig. 5
ROTATION
Change lever
ROTATION+IMPACT
Fig. 6
Switch Trigger