Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the valve connector from the tyre valve.
Replace the tyre valve dust cap.
Note:- The gauge on this compressor is for guidance only. Check pressure with a known
accurate gauge.
The compressor can be used without the engine running but this will drain the power
from the battery.
Inflatable and Leisure Inflation
Select the suitable adapter and screw into the valve connector.
Adapters are clipped onto the rear of the compressor under the coiled power cable.
Insert the connector adapter into the appropriate inlet of the inflatable
Plug the 12v DC plug into the vehicle 12v socket. (Fig 1) Press M button to select
pressure gauge measurement from Bar, Kg/cm², Psi (Fig 3)
Caution:
Only inflate product to the manufacturer's specifications
Hold + or – for approx 5 seconds until LCD display flashes. Set the required pressure
using the + or – buttons then wait 2-3 seconds. The LCD will display the current
pressure value to which the item will be inflated.
Push the ON/ OFF for the compressor to start. When the pressure gauge reaches the
required value the compressor will automatically switch off and the LCD display will
show "OFF".
Push the ON/ OFF button to switch the compressor off.
Remove adapter from the inflatable and remove adapter from the connector.
Replace the adaptor to the storage clip.
Typical Inflation Pressure (guide only)
Mountain bike tyres
Football
Volleyball
Conversion Chart
psi
KPa
BAR
10
68.9
0.7
20
137.9
1.4
30
206.8
2.1
40
275.8
2.8
50
344.7
3.5
Specification Table
Power supply
Max Amperage
Pressure measurement range
Power cable length
Air hose length
Operation temperature
35-50psi
Road bike
13psi
Basketball
5psi
Lawn tractor tyre
psi
KPa
70
482.6
80
551.6
90
620.5
100
689.5
125
861.9
12v DC
10 amps
0 – 100 psi
3.3m
650mm
-20˚C to +60˚C
90-100psi
9psi
22psi
BAR
4.8
5.5
6.2
6.9
8.6
Publicidad
Tabla de contenido
