Features; Assembly - Ryobi CSB144LZ Manual Del Operador

PRODUCT SPECIFICATIONS
Blade Diameter ......................................................7-1/4 in.
Blade Arbor .............................................................. 5/8 in.
Cutting Depth at 0º ..............................................2-7/16 in.
Cutting Depth at 45º ..............................................1-7/8 in.
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
All manuals and user guides at all-guides.com

FEATURES

Cutting Depth at 51.5º .......................................1-11/16 in.
No Load Speed .................................... 5,200 r/min. (RPM)
Input ....................................... 120 V, AC only, 60 Hz, 15 A
Laser Guide ........................ Class IIIa, <5mW max, 650nm

ASSEMBLY

INSTALLING/REMOVING THE BLADE
See Figures 2 - 3, page 16.
To install the blade:
 Unplug the saw.
 Depress and hold spindle lock button.
 Remove blade screw by turning it counterclockwise with
 Remove spring washer and outer blade washer ("D"
 Wipe a drop of oil onto the inner flange bushing and outer
 Retract the lower blade guard into the upper blade guard
 Check to see that the saw teeth and arrow on the saw
7 - English
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of
the saw. Also, never use a blade that is too thick to
allow outer blade washer to engage with the flat on the
spindle. Larger blades will come in contact with the blade
guards, while thicker blades will prevent blade screw from
securing blade on spindle. Either of these situations could
result in a serious accident.
NOTICE:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
the blade wrench, while keeping the spindle lock button
depressed.
washer).
blade washer ("D" washer) where they contact blade.
using the lower blade guard handle. Make sure the lower
guard spring works properly, allowing the guard to move
freely.
blade and the arrow on the upper guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the saw
as shown.