Fcc Compliance Statement - AIPTEK 3D P8 Manual Del Usuario

User's Manual
18. To clean the screen, cut off the power supply first and use a damp soft cloth to wipe it.
Never apply alcohol, gasoline or other chemical agents. Use only accessories supplied by
the manufacturer.
19. This product supports hot plugging of memory cards. However, it is suggested to power off
the product before plugging/unplugging your memory card to protect the memory card.
20. Use only the accessories supplied by the manufacturer.
21. Both product and user's manual are subject to further improvement or supplement without
further notice.

FCC Compliance Statement:

This device complies with Part 15 of the FCC Rules. Operation is
subjected to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in residential installations. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television equipment reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Move the equipment away from the receiver.
- Plug the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/television technician for additional suggestions.
You are cautioned that any change or modifications to the equipment not expressly approved
by the party responsible for compliance could void Your authority to operate such equipment.
Disposal of waste batteries (applicable in the European Union
and other European countries with separate collection
systems)
This symbol on the battery or on its packaging indicates that the battery provided
with this product shall not be treated as household waste.
On certain batteries, this symbol might be used in combination with a chemical
symbol. The chemical symbols of mercury (Hg) or lead (Pb) are added if the
battery contains more than 0.0005% mercury or 0.004% lead.
To ensure the battery will be treated properly, hand over the product at end-of-life to the
applicable collection point for the recycling of electrical and electronic equipment and hand the
battery over to the applicable collection point for recycling of waste batteries.
www.aiptek.eu
If the life time of the product ends, try to recycle all
components, if possible. Batteries and rechargeable batteries
must not be disposed with household waste! Please dispose
them at a local recycling center. Together we all contribute to
the protection of our environment.