Publicidad
Idiomas disponibles
Idiomas disponibles
Individuals who have not read the instruction manual and
are not familiarized with how to operate the high-pressure
washer, must not use it.
Before using the appliance, replace damaged and used
parts.
Check that all nuts and screws are properly tightened. It is
important to inspect regularly the equipment in order to
ensure safety issues and a good performance.
To ensure that you work with the power tool safely, you
should take into account a few precautions and procedures
before start-up:
▪ The washer's components and accessories are correctly
assembled;
▪ The safety devices are in perfect condition and function
properly. Never use the power tool if the safety devices
are missing, inhibited, damaged or worn out;
▪ The high-pressure hose, spray gun and couplings are in
perfect conditions.
Make all adjustments and work necessary for the correct
assembly of the power tool if you have any questions or
difficulties, contact your official dealer.
Keep third parties away from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Use the appliance with special caution when working near
slopes, ditches and wells. Place the equipment on a firm
and flat floor, at a safe distance from these danger
locations.
The control and safety devices installed in the power tool
must not be removed or inhibited.
Starting the washer
Switch on the power tool carefully following the operating
instructions. Using the appliance according to these
instructions reduces the risk of injury.
Do not cover the washer during operation or use it in a room
without proper ventilation! To avoid the risk of overheating,
keep the ventilation slots permanently clean and
unobstructed so that air can flow.
Do not expose the appliance to sunlight or use it for long
periods of time. Such conditions cause overheating, which
leads to a constant activation of the appliance's thermal
relay.
Operating the high-pressure washer with a supply voltage
lower
than
the
recommended
specifications or using extension cords with a very long
cable can also cause the constant tripping of the thermal
relay.
Before performing cleaning, adjusting, repairing and
maintenance works, you should:
▪ Place the device on a firm, flat floor;
▪ Unplug the power cord.
Check the appliance frequently especially before storage
(e.g. before winter period), regarding wear and damage.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool must be carefully cleaned after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
in
the
technical
Publicidad
