Adler europe AD 4082 Manual De Uso página 4

Contact professional electrician in this matter.
15.Do not put your fingers or any other objects into the cup when the device is turned on.
16. Make sure that long hair, scarves, ties, etc. do not hang over the cup and working
parts of the device.
17. For safety reasons, only original accessories and spare parts should be used.
18. When removing accessories, handle the blades very carefully: they may injure.
19. Changes to the accessories may only be made when the device is switched off.
Before change disconnect device from the power supply.
20. Do not put anything other than food into the chopper bowl. Do not put hot products
and liquids (over 80°C) into the bowl.
21. Do not use the appliance to crush ice, bones or other hard products.
22. Make sure the cover is properly fitted before turning power on the device.
23. The appliance is not suitable for whipping eggs and kneading dough.
24. To clean the housing, do not use aggressive detergents, as they may remove the
applied graphic informational symbols such as: scales, markings, warning signs, etc.
25. THE MAXIMUM CONTINUOUS WORKING TIME OF THE CHOPPER IS 15 sec.
After 15 sec. continuous operation, wait 2 minutes before restarting it.
26. If the blades become jammed, always unplug the power cord from the electrical outlet
before removing the blockage.
27. Do not move nor lift the device while it is working.
28. Handle the blades carefully to avoid injury. Be careful when handling cutting blades,
when emptying the bowl and during cleaning.
29. Always disconnect chopper from the power supply when it is left unattended and
before assembling, disassembling or cleaning.
DESCRIPTION OF THE DEVICE
A1. A2. On / off pulse buttons
C. Cover
E1. Top set of blades
IMPORTANT NOTES:
1. Do not operate the device continuously for more than 15 seconds, after this time leave it for 2 minutes to cool.
2. Do not operate the device when the bowl is empty.
3. Do not pour hot liquids (over 80°C) into the bowl.
BEFORE FIRST USE
Remove all protective elements and thoroughly clean the device before the first use.
Assemble blades if necessary.
HOW TO ASSEMLBE BLADES
Place top set of blades (E1) on the shaft of the lower set of blades (E2).
Carefully move top set of blades (E1) clockwise until you hear "click" sound. To disassemble move top part (E1) anti-clockwise.
ATTENTION: Blades are sharp!
USING THE DEVICE:
1. Place the bowl (D) on a flat and stable surface.
2. Place the blades (E1 and E2) on the guide pin in the bowl (D). Carefully push down the blades all the way down. Hold down and
spin to check if they are mounted correctly.
3. Put ingredients into the bowl (D).
4. Place the cover (C) on the bowl.
5. Place the motor unit (B) on the tip of the blades. Move it to fit the cover (C).
B. Motor unit
D. Bowl
E2. Lower set of blades
4