Overhead Rigging - Briteq COB PAR56-100WW Manual De Instrucciones

ENGLISH
 The housing and the lenses must be replaced if they are visibly damaged.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. FILTER FRAME CLIPS: can be used to install color filters etc.
2. BRACKET: with knob to fasten the unit and a mounting hole to fix a mounting hook.
3. DMX INPUT: 3pin male XLR-connector used to connect the projector with the DMX controller or with the
previous unit in the DMX chain.
4. DMX OUTPUT: 3pin female XLR-connector used to connect the projector with the next unit in the DMX
chain.
5. DISPLAY shows the various menus and the selected functions.
6. DOWN button: to lower the values shown on the display.
7. UP button: to increase the values shown on the display.
8. ENTER button: used to confirm your choice or to enter the setup mode of a function.
9. MODE button: used to browse the different functions in the menu
10. Mains input: equipped with a 1.3m mains cable.
11. Fuse holder: always replace a damaged fuse with a fuse of the same type and electrical specifications!

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
BRITEQ
®
3/39
USER MANUAL
COB PAR56-100