Uline VACMASTER H-9464 Manual Del Usuario página 8

4. Clear all dirt or debris from
collection tank and hose.
(See Figure 35)
5. Clean or replace filter.
6. Check the hose, attachments
and power cord to verify that they
have not been damaged.
7. Place power head on collection
tank and secure latches.
IMPORTANT! Clean or change the cartridge
filter regularly for best performance. Always
use cartridge filter for dry vacuuming. If the
machine is used without the cartridge filter, the
motor will burn out and the warranty will be
voided. Always keep spare filters on hand.
NOTE: Before storing vacuum,
empty and clean collection tank.
Wrap cord and hang on hook of
handle. Hose and accessories
should be stored as illustrated
above. Store unit indoors.
(See Figures 36-38)
INSTALLING CARTRIDGE FILTER
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 39)
2. Remove power head and place
in upside down position.
PAGE 8 OF 30
MAINTENANCE CONTINUED
Figure 35
Figure 36
INSTALLING AND CLEANING CARTRIDGE FILTER
Figure 39
NOTE: Filters included are made of high-quality
materials designed to stop small dust particles.
The cartridge filter should be used for dry
pickup only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it
will clog quickly and be difficult to clean.
NOTE: Handle filter carefully when removing it
for cleaning and replacement. Check filter for
tears or small holes. A small hole can let dust
pass through and out of the filter. Do not use a
filter with holes or tears; replace it immediately.
WARNING! Always disconnect plug from
outlet before removing the power head from
collection tank.
STORAGE
Figure 37
3. Install cartridge filter over the filter
cage with the flat end of filter
toward the power head.
(See Figure 40)
4. Carefully push filter in until it stops
against the power head.
(See Figure 41)
Figure 38
Figure 40
Figure 41
0821 IH-9464