Password Protection - PRASTEL MR Serie Guia De Inicio Rapido

MR series Receivers
6. SELECTION OF TYPE OF OUTPUT RELAY
•
Power up the receiver correctly.
•
Press button "SET": the first led strat flashing according to programmed output mode.
•
Group of only one flash means monostable output setted.
•
Group of two flashes means bistable output setted.
•
Group of three flashes means timed output setted.
•
Select the relay you wish to set pressing "SET" button repeatedly.
•
To change selected releay setting:
•
Turn the trimmer wheel according to the arrow printed on the board: left end stroke select monostable
function, right end stroke bistable output. Midway positions select timed output as shown in figure below.
•
Press "ENTER" button to save new setting into the selected relay.
•
To set other relay press the "SET" button.
•
To exit programming mode just select the last relay and then press the "SET" button another time. The led
goes out. Exit from the programme comes about automatically in any case 10 seconds after the last
memorisation.
250
250
200
150
100
50
0
0
0
7.

PASSWORD PROTECTION

On board memory con be proteced with a numeric Password via PC link and WinGTProg software. Password must be a number in
the range from 1 to 65535. If Password is from 1 to 32767 only programmation / delation of user data through "ENTER RADIO" button
is disabled. If Password is from 32768 to 65535 either programmation / delation of user data and programmation of relays through
"SET" button are disabled.
LAYOUT OF BUTTONS AND TERMINAL BOARDS
50 100
Valore letto dall'ADC
Trimmer Race (from left end to right end) and corresponding
switching time for timed relay output
ENGLISH
150 200
Terminal
Number
1 Power Supply – 12/24V AC/DC
3 GND
2 Antenna core
4 Antenna GND
5 - 7 Output Relay 1
6 - 8 Output Relay 2
9 – 11 Output Relay 3 (only 4 channels version)
10 – 12 Output Relay 4 (only 4 channels version)
4
ISMREU_03_09.doc
250
Terminal Function