Reggiani REVIOS Serie Instrucciones Para La Instalación página 11

REVIOS | ENG |
version) and by -65°/+90° (for the version
with vertical control gear) on the vertical
axis.
ACCESSORIES
Honeycomb louvres can be used to pre-
vent glare with a 30-50% reduction in the
luminous flux. They must be fi tted when
the reflector is mounted.
1 Fit the louvre onto the IOS reflector
(fig.3 )

2 Insert the reflector with louvre into the
optical compartment (fig.3
3 Press and turn the reflector with louvre
clockwise until it snaps into place (fig.3
)
C
For other types of accessories, the type of
dimming and the type of emergency light-
ing, refer to the catalogue or access the
product datasheet on the website:
www.reggiani.net/codice
When assembling accessories, please re-
fer to the instructions accompanying the
individual components.
INSTALLATION/
REPLACEMENT OF
REFLECTORS AND LIGHT
SOURCES
The luminaire can be fitted with two types
of light source: LED and metal halide
www.reggiani.net
lamps. For more information about the
light sources, refer to the catalogue or
access the product datasheet on the web-
site: www.reggiani.net/reference.
After installation of the projector and
before powering the system, install or re-
place the refl ector and light source.
)

• For metal halide lamps:
Metal halide lamps MT/UB G8.5 – G12,
20/35/50/70W
Remove the safety reflector by turning

it anti-clockwise (fig.4);
insert/replace the lamp (with one of

equal rating as the ballast, see rating
plate);
re-engage the reflector correctly by
C
turning it clockwise.
N.B. Always check the safety glass for
intactness and for perfect fitting on the
locking ring
Warning: when the lamp is dying – i.e. the
luminous fl ux is decreasing – it must be
replaced to prevent serious damage to the
control gear.
Turn the electricity off at
the mains and follow the
instructions below.
011
4

4

4
C