CA-800-Install.book Seite 31 Mittwoch, 20. Februar 2008 12:28 12
CoolAir
✓ The first digit of the display (see fig. 7 on page 5, Pos. 5) shows the
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode and switches off.
➤ Press the ON/OFF button to quit configuration mode.
6.3.2 Menu level 1: Set temperature
The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 7 on page 5, Pos. 5) shows the
➤ Press the operating mode button (see fig. 7 on page 5, Pos. 4) to
➤ Use the + or - buttons (see fig. 7 on page 5, Pos. 6 and 7) to select the
✓ The digits in the display flash until the parameter you enter is confir-
➤ Press the operating mode button (see fig. 7 on page 5, Pos. 4) to
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 1 and can use the + and - buttons to switch
6.3.3 Menu level 2: Low-voltage cut-off
The battery monitor protects the battery from discharging too low.
When the the battery monitor switches the device off, the battery only has
a proportion of its charging capacity. Avoid starting repeatedly or operating
electrical consumers. Ensure that the battery is recharged. As soon as the
required voltage is available, you can restart the system.
If the roof air conditioner only has the supply voltage set here, the system
is switched off.
➤ Start configuration mode (see chapter "Start and end configuration
All manuals and user guides at all-guides.com
menu level and the second and third show the parameter which can
1.17
be set – for example,
mode" on page 30).
menu level and the second and third show the parameter which can
be set.
change the parameter.
temperature (in °C) with which the system starts.
med.
confirm your entry.
between menu levels.
mode" on page 30).
for menu level 1 and a set value of 17 °C.
Installation
31