Tabla de contenido
Publicidad
Step 3: Place the vehicle lap belt under the armrest on both sides. Pull the vehicle diagonal
belt on the vehicle buckle side through the red belt guide under the armrest (Fig. 4.2-4). Make
sure adult belt has not become twisted (Fig. 4.2-5).
Step 4: Press your knee on the child car seat and pull the diagonal belt along the direction as
the picture shows (Fig. 4.2-6). Make sure that belt has not loosened. Tighten the diagonal
shoulder belt in the direction of the automatic roll-up as possible (Fig. 4.2-6).
The satisfactory position of the adult safety-belt relative to the child car seat is as the Fig. 4.2-
6. You can contact the child car seat manufacturer if in doubt about this point.
To release your child seat following the above instructions in reverse order.
Ensure that each part of the belt is tightened as possible. Make sure all the belts' position is
right and they has not become twisted. Also check that the cover is not impeding the
movement or fit of the belt webbing in any way.
4.3 Loosening the harness
●
The harness is slackened by pressing the lever (under the seat cover) on the front of the
seat (H).
●
Press down on the label marked 'Press" as you grip the two shoulder straps with your
other hand. Pull the shoulder straps towards you to loosen the harness (Fig. 4.3).
4.4 Securing the child with the harness
●
Firstly, adjust the shoulder belts height (see point 4.1), proceed as follows:.
●
Loosen the harness (see point 4.3), open the buckle (4.4.1) and place them down
sideways.
●
Seat your child in the child car seat. Place both shoulder belts over your child's shoulders.
●
Fasten the buckle (4.4.1).
●
Pull the shoulder straps upwards to remove the slack from the lap sections of the harness
then pull the adjuster strap (I) until the harness is fully tightened (Fig. 4.4).
●
The harness should be adjusted as tightly as possible without causing discomfort to your
child.
●
A loose harness can be dangerous. Check the harness adjustment and tighten each time
the child is placed in the seat.
Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged, the belt is not
twisted.
4.4.1 Using the buckle
●
Put the two metal sections of the buckle connectors together (Fig. 4.4.1-1).
●
Slot the two buckle connectors into the slot in the top of the buckle until they "click" into
place (Fig. 4.4.1-2).
●
Check the harness is correctly locked by pulling the shoulder straps Upwards (Fig. 4.4.1-
3).
●
To release the harness, press the red button on the buckle downwards.
31
Publicidad
Tabla de contenido
