Charging & Operation - Motorhead MH-03-RS-B1-0-1 Manual De Instrucciones

20V ULTRA Reciprocating Saw 2Ah KIT (MH-03-RS-B1-0-1)
CHARGING & OPERATION
Charging The Battery Pack
Chargers are designed to use standard 120 volt AC, 60 Hz power. Do not use DC or any
other voltage.
BEFORE ATTEMPTING TO CHARGE YOUR BATTERY PACK, THOROUGHLY READ ALL
THE SAFETY INSTRUCTIONS.
• Batteries will reach full performance after about five charge/discharge cycles.
•
avoid unintentional starting.
• The step of the battery pack has positive and negative terminal markings on it. Align
these with the identical markings on the top of the charging stand and insert pack into
base. (Pack will not insert properly if reversed)
• Normal charging time is 1hr for 2Ah battery. The charger will charge the battery at the
normal
charging is complete. After the battery is fully charged according to the charging time
provided in the instructions, remove the battery pack from the charger. Battery
temperature will cool to normal.
• When charging more than one battery pack, allow 15 minutes between charges.
• After many charge/discharge cycles, your battery will lose its ability to hold a charge.
It should then be replaced. Dispose of batteries at an appropriate waste disposal
facility. Do not throw batteries away in common trash receptacles.
• Place and charge the Battery Pack on a dry fireproof location in a room where the
temperature is from +39.2°F(4°C)-104°F(40°C).
• During charging the battery, the Battery Pack, Charger may become warm when you
touch it. This is a normal condition, and does not indicate a problem.
• lf recharging a newly spent Battery pack, make sure it is undamaged and cool
completely.
• Always unplug the Charger when charging completed.
• Be sure the battery is cool before using it.
- Charging indications
Indicator lights
• Insert the switching charger into a 120V household current receptacle.
• The green light is the charge indicator. When the charger is connected to AC
household current, the green light is on.
• The red light is the power indicator. When the battery is properly inserted into the
charger and charging, the red light is on.
12
20V ULTRA Reciprocating Saw 2Ah KIT (MH-03-RS-B1-0-1)
- Inserting and removing the battery
• To insert, simply push pack in until lock spring clicks.
• To remove battery pack from the tool, press the lock spring buttons (F in the functional
description) and pull out.
SWITCH (E in the functional description)
• Make sure the battery pack is installed.
description) towards left or right and squeeze
the ON/OFF switch trigger (E in the functional
description).
trigger (E in the functional description).
- Variable speed
• This tool has a variable speed switch that
delivers higher speed and torque with increased
trigger pressure.
• Speed is controlled by the amount of switch
trigger depression.
- Install or remove the saw blade
WARNING: Before making any adjustments
button in the centre position and remove the
battery from the saw.
To avoid accidental start, check to make sure
switch trigger.
• Rotate the Quick-release blade clamp (C in the
functional description) anticlockwise with hand.
13
D
D
E
E