2.Explanation of Symbols on the Machine
For safe operation and maintenance ,symbols are carved in relief on the machine .
According to these indications ,please be careful not to make any mistake.
The port to refuel"MIX GASOLINE ",
Position:Fuel cap
The port to top up chain oil
Position:Oil cap
Setting the switch to the "O"position ,the engine stops immediately.
Position:Rear-left of the unit.
Starting the engine .If you pull out the choke knob(at the back –right of the rear handle )to the
point of the arrow,you can set the starting mode as follows:
●
●
Position:Upper-right of the aircleaner cover
H
The screw under the "H"stamp is The High-speed adjustment screw.
The scew under the "L"stamp is The Slow –speed adjustment screw.
L
The screw at the left of the "T "stamp is the ldle adjustment screw.
T
Position:Left side of the rear handle
Shows the directions that the chain brake is released(white arrow)and activated (black arrow).
Position:Front of the chain cover
If you turn the rod by screwdriver follow the arrow to the "MAX"position, the chain oil flow
more,and if you turn to the "MIN" position less.
Position:Bottom of the power unit
First-stage position –starting mode when the engine is warm.
Second-stage position –starting mode when the engine is cold .