Turning Your Headset On And Off; Pairing It With Your Phone - Netcom Jabra WAVE Manual Del Usuario

TURNING YOUR HEADSET ON AND OFF

- Slide the on/off button towards the symbol "I" to turn the
headset oN. When you do so both indicators will lash on the
Jabra StatusDisplay™.
- Slide the on/off button towards the symbol "o" to turn the
headset off.

PAIRING IT WITH YOUR PHONE

Headsets are connected to phones using a procedure called
'pairing' . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1 Put the headset in pairing mode
- When you turn on your Jabra WAVE for the irst time, the headset
will automatically start up in pairing mode – i.e. it is discoverable
for your phone. When the headset is in pairing mode the Bluetooth®
status indication on the StatusDisplay™ is lashing.
2 Set your Bluetooth® phone to 'discover' the WAVE
- Follow your phone's instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. then set your
phone to discover new devices. this usually involves going
to a 'setup,' 'connect' or 'bluetooth' menu on your phone and
selecting the option to 'discover' or 'add' a Bluetooth® device.*
3 Your phone will ind the Jabra WAVE
- Your phone will ind the headset under name "Jabra WAVE".
Your phone then asks if you want to pair with the headset.
Accept by pressing 'Yes' or 'oK' on the phone. You may be
asked to confirm with a passkey or PIN. then use 0000 (4
zeros). Your phone will conirm when pairing is complete and
the Bluetooth® status indication on the StatusDisplay™ will
shift from lashing light to steady light and the headset voice
guidance will say "connected".
* Phone dependent
JAbRA WAVE
5