Installing A Prewound Reel - Cub Cadet ST2020 Manual Del Operador

Single Line Installation
Go To Step 8 for SplitLine™ Installation
6. Take approximately 18 feet (5.4 m) of new trimming line, loop it into two
equal lengths. Insert each end of the line through one of the two holes in
the inner reel (Fig. 19). Pull the line through the inner reel so that the loop
is as small as possible.
7. Wind the lines in tight even layers, onto the reel (Fig. 20). Wind the line in
the direction indicated on the inner reel. Place your index finger between
the two lines to stop the lines from over-lapping. Do not overlap the ends
of the line. Proceed to step 11.
SplitLine™ Installation
8. Take approximately 9 feet (3 m) of new trimming line. Insert one end of
the line through one of the two holes in the inner reel (Fig. 21). Pull the
line through the inner reel until only about 4 inches is left out.
9. Insert the end of the line into the open hole in the inner reel and pull the
line tight to make the loop as small as possible (Fig. 21).
10. Before winding, split the line back about 6 inches.
11. Wind the line in tight even layers in the direction indicated on the inner reel.
NOTE: Failure to wind the line in the direction indicated will cause the
cutting head to operate incorrectly.
12. Insert the ends of the line into the two holding slots (Fig. 22).
MAINTENANCE AND REPAIR INSTRUCTIONS
Loop
Fig. 19
Fig. 20
Loop
Fig. 21
Holding Slots
Fig. 22
13. Insert the ends of the line through the eyelets in the outer spool and
place inner reel with the spring inside the outer spool (Fig. 23). Push the
inner reel and outer spool together. While holding the inner reel and
outer spool, grasp the ends and pull firmly to release the line from the
holding slots in the reel.
NOTE: The spring must be assembled on the inner reel before reassembling
the cutting head.
14. Hold the inner reel in place and install the bump knob by turning
counterclockwise. Tighten securely.

INSTALLING A PREWOUND REEL

1. Hold the outer spool with one hand and unscrew the bump knob
clockwise (Fig. 15). Inspect the bolt inside the bump knob to make sure
it moves freely. Replace the bump knob if damaged.
2. Remove the old inner reel from the outer spool (Fig. 16).
3. Remove the spring from the old inner reel (Fig. 16).
4. Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner reel before reassembling
the cutting head.
5. Insert the ends of the line through the eyelets in the outer spool (Fig. 23).
6. Place the new inner reel inside the outer spool. Push the inner reel and outer
spool together. While holding the inner reel and outer spool, grasp the ends
and pull firmly to release the line from the holding slots in the spool.
7. Hold the inner reel in place and install the bump knob by turning
clockwise. Tighten securely.
Spring
Fig. 23
11