Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING TO NON-STEEL TOP
1. To free drawer from housing, fully extend the drawer
from the housing. Flip one plastic tab on the sliding
rails up and the second plastic tab on the sliding
rails down. Drawer is now unlocked from housing
and can be removed. (See Figure 3)
Drawer
Figure 3
2. Turn the packing table over. Position the drawer
housing in the desired location. Use the drawer
housing as a template to mark the location of the
four holes for wood screws on the underside of the
top. Using 5/32" drill bit, drill holes into the wood top
about 1/2" to 3/4" deep.
3. Attach the drawer housing to the top using four
wood screws. (See Figures 4-5)
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
Tab
Screw
1-800-295-5510
uline.com
Figure 5
4. Insert the drawer and turn packing table right side
up. Cycle the drawer in and out a few times to
check operation.
NOTE: The drawer and suspension have a
70 lb. weight capacity.
0621 IH-7595
Publicidad
