Publicidad
Idiomas disponibles
Idiomas disponibles
3
Description
3.1
Product overview
3.2
Intended use
The product described is a hand-held cordless nibbler. It is designed for cutting sheet-like workpieces out of
punchable materials such as steel, aluminum, non-ferrous metal and plastic, for nibbling straight or curved
outside edges and cut-outs and for nibbling along marked lines of cut. The nibbling process produces
distortion-free cut edges. Other applications are possible as well, depending on the accessory tool used.
SPN-CN: This accessory tool is also designed for cutting pipes, nibbling corrugated metal and nibbling with
a template. The hollow round punch enables the nibbler to be rotated about its own axis so that nibbling can
proceed in any direction.
SPN-RN and SPN-RL: These accessory tools are also designed for cutting sheet metal profiles such as
trapezoidal sheet metal, corrugated sheet metal, box-section sheet metal and angled moldings.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
•
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
•
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3
Items supplied
Nibbler, Torx wrench, operating instructions
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group
Before being dispatched, the product was tested to ensure that it is in full working order. There
workpiece used in testing might have left tiny scratches in the surface of the housing.
3.4
Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the product stalls or slows significantly due to overloading, relieve the pressure applied to the product and
then allow it to run under no load for approx. 30 seconds.
6
English
1
Lockable on/off switch
@
Grip
;
Adjusting knob for speed
=
Battery status indicator
%
Battery release button
&
Battery
(
Dust filter
)
Indexing pin
+
Die carrier
§
Securing screws
/
Die
:
Cover ring
∙
Punch
$
Punch guide
£
Casing
|
Accessory tool, SPN-CN
¡
Accessory tool, SPN-RN
Q
Accessory tool, SPN-RL
W
2331867
*2331867*
Publicidad
