Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION 2
Drill out the mark points in the fixture base (B) according with the
2b
mounted J-box holes.
B
Assemble the lens (A) with the fixture base (B) after connecting the connector
4b
of PCB and driver. Then tighten with lens screws. Apply silicone sealant (not
included) between the fixture and the wall.
B
A
B
WARNING: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could lead to electric shock, fire, or
other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the circuit breaker. • This
product must be installed in accordance with the applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved. • Risk
of electrical shock. To reduce the possibility of serious injury, always take the proper precautions and unplug the fixture before moving or cleaning.
NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna, increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from that to which
the receiver is connected, and consult the dealer or an experienced radio/TV.
NOTICE: Suitable for operation in ambient temperatures not exceeding 113°F/45°C. • Suitable for wet locations.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
Mark points
Φ 0.2in.
(5mm)
Connector
Silicone sealant
(not included)
Lens screw
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
1-855-ETI-SSLI (1-855-384-7754) www.ETiSSL.com
Put the Gasket (EE) on the back of fixture base (B). Connect the AC wires and the driver
3b
wires by wire nut (BB). Mount the fixture base (B) into the j-box with fix screw (DD).
NOTE: AC wires should go through one of the 5 conduit entry holes on the fixture
base (B).
BB
B
Conduit entry holes
ADJUSTING THE COLOR TEMPERATURE AND LUMEN
This LED light fixture allows you to customize the color temperature and lumen.
Move the toggle switch on the fixture base (B) to make your selection before attaching the
lens (A) to the fixture plate (B).
Choose the color temperature (CCT) from three options: 3000k Soft White, 4000k Cool
White, or 5000k Daylight.
Choose the lumen from two options: high/ low lumen option (High for 100% brightness and
low for 50% brightness).
NOTE: The factory setting for the correlated color temperature (CCT) is 3000K, and
the lumen is 100% brightness.
Color temperature (CCT) options:
3000K 4000K 5000K
DD
EE
Lumen options:
100% / 50%
Publicidad
