Descargar Imprimir esta página

Shutting Down; Care And Maintenance - Kärcher IVM 60/30 M Z22 Manual Del Usuario

Ocultar thumbs Ver también para IVM 60/30 M Z22:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
 Remove disposal bag.
 Dispose of the disposal bag according to the local
provisions.
 Reinsert the container.
 Turn off the appliance.
 Push the handle of the container downwards. Con-
tainer is locked
WARNING
Risk of crushing! Watch out for moving parts when re-
moving and replacing the container.
 Plug in the pressure balancing.
General
CAUTION
Please observe the local provisions regarding the
wastewater treatment.
On completion of wet vacuum cleaning: Dry the fil-
ter. Clean the container with a moist cloth and dry
it off.
Cleaning the filter
Clean the star folded filter at regular intervals.
 Turn off the appliance.
 If dry suction material has been vacuumed, move
the lever for the filter cleaning back and forth sev-
eral times, but 5 times at least.
If this cleaning does not bring about any improvement,
then remove the filter and wash it or replace it (see
chapter "Replacing the filter").
Turn off the appliance
 Switch off the appliance at the rotating knob.
 Pull out the mains plug.
Indicator lamp "Ready for use" turns off.

Shutting down

 Turn off the appliance.
 Pull out the mains plug.
 If necessary, dismantle the accessory and rinse it
with water and let dry.
 Empty the vacuuming material container (refer
chapter "Emptying vacuuming material container").
 Vacuum and wipe the appliance inside and outside
with a damp cloth.
 If wet suction material has been vacuumed, re-
move the filter for drying.
Emptying the vacuuming material container
Note
The vacuum material container must be emptied when
it is has filled up to approx. 3 cm below the upper edge.
Regularly check the filling level in the dirt receptacle,
since the device does not switch off automatically.
 Lock parking brakes.
Illustration
 Unplug the pressure equalizer at the lower end.
 Pull the handle of the container upwards. The con-
tainer is unlocked and lowered.
 Switch on device to avoid releasing dangerous
dusts.
 Pull the container out by the handle.
 Empty the container.
 Reinsert the container.
 Turn off the appliance.
 Push the handle of the container downwards. Con-
tainer is locked
14
Note
The vacuum material container can be lifted by cranes
at the handle. Maximum load for crane transport: 50 kg.
CAUTION
Risk of injury and damage! Note the total weight of the
vacuum material container when transporting with a
crane. Do not overload the container. Observe instruc-
tions on lifting with a crane.
WARNING
Risk of crushing! Watch out for moving parts when re-
moving and replacing the container.
 Plug in the pressure balancing.
CAUTION
Risk of injury and damage! Observe the weight of the
appliance when you transport it.
 Close the suction connection, see operating in-
structions.
 Release the park brakes and push the appliance by
the push handle.
 When transporting in vehicles, secure the appli-
ance according to the guidelines from slipping and
tipping over.
CAUTION
Risk of injury and damage! Note the weight of the appli-
ance in case of storage.
This appliance must only be stored in interior rooms.

Care and maintenance

DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
Dust extracting machines are safeguards for the pre-
vention or elimination of hazards defined in the regula-
tions of BGV A1.
In order to carry out maintenance work, the user
must disassemble, clean and service the unit, in so
far as this is possible without endangering mainte-
nance personnel and other persons. Suitable pre-
cautions include decontamination before the unit is
disassembled. Precautions must be taken for local
filtered forced air ventilation at the place where the
unit is disassembled, the cleaning of the mainte-
nance surface and suitable protection of the per-
sonnel.
The outside of the unit should be cleaned thorough-
ly and any harmful substances removed. Alterna-
tively, a sealed coating may be applied before the
unit is removed from the danger area. All unit parts
are to be considered contaminated when they are
removed from the danger area. To avoid distribu-
tion of the dust, you must take the appropriate
measures.
In the framework of maintenance and repair work
all contaminated objects that cannot be cleaned
satisfactorily must be disposed of. Such objects
must be disposed of in impermeable bags in ac-
cordance with the valid provisions for the disposal
of such waste.
When transporting or maintaining the device, the
suction opening must be closed with the plug.
– 4
EN
Transport
Storage

Publicidad

loading