Temper koban KEH35-400C Manual página 25

KEH35-400C
Hydraulic Crimping Tool
(2 ) Eliminate breakdown Q & A ：
1. Q ： How to add oil in the inside of tool when the oil is not full enough?
A ： What was the cause of shortage of oil inside?
< 1> It causes the oil ev aporated by using for a long peri od.
< 2> It causes leak oil by improper uses or moving.
Condition < 2 > : Please return the tool to s uppli er.
Condition < 1 > : Please follow below ste p s (Figure 5, Figure 6, Figure 7) for
Figure 5. Take out the Fixed Handle
Finish adding oil, p lease reassemble the p arts in s eque nce.
2. Q ： The die cannot be p ositioned while pr essing.
A ： The causes are:
< 1> Shortage of Oil
< 2 > Air inside
< 3> Impurities inside the reservoir
< 4> Impurities inside the tool
them. Then reassemble them.
adding oil.
Please fill in oil in the reservoir u p to full.
Please add oil in the reservoir up to full.
Fi gu re 6.
T a k e ou t th e
plug
Exchange new Hydraulic oil.
Take a p art the inner p arts and clean
7
Figure 7. Add oil
www.grupotemper.com