LEGRAND 84424 Manual Del Usuario página 3

OUTDOOR SIREN WITH FLASH
Acoustic and optical outdoor warning designed to
contain the self-supply battery.
Acoustic signaller
84424 and 683157 sirens comply with
level 2 of the CEI 79-2 standard
OUTDOOR SIREN CONFIGURATION
The outdoor siren requires the configuration of the
progressive number to be performed by means of jumper (1).
If the system has 2 outdoor sirens jumper (1) of the second
siren must be cut.
OUTDOOR SIREN INSTALLATION
1 - Unscrew the two screws (1) and remove the external cover (2).
2 - Remove the four screws (3) and extract the internal protective cover
(4)
3 - Using the drilling template (5) position the hole (6) in correspondence
with the wire outlet pipe and mark the 5 holes.
NOTE: for the drilling use a 6 mm drill.
5
6
9
Wall
Drilling template
12
Features
The MAX at the input terminals:
Input/output and power supply
Housing for 12 V battery
Alarm autonomy
Alarm sound intensity
Frequency
Flashing
Flashes per minute
Weight (without battery)
IP degree of protection
Optical signaller
Room operating temperature
Self-protected against removal and opening
Fuse for battery protection
Yellow led
7
8
10
Wall
11
A
B
Yellow
led
- -normal operation
- alarm
- battery charging
A SIREN INTERNAL
1
CARD
B
4 - Put the rawlplugs into the holes and partially tighten the two upper
screws (7) and the "tamper" screw (8).
5 - Adjust the "tamper" screw using the notch (9) on the drilling
template as shown in the figure.
The system cannot be used if the tamper screw is not
installed or not adjusted correctly.
6 - Hook the siren to the two upper screws (10). Screw in the two lower
screws (11). Tighten the four screws completely.
7 - Install the battery, (12) 12 V - 12 Ah in its location, without connecting
the Faston terminals.
8 - On the siren internal card connect the power supply pair (BUS) to
the white cords (A), the battery to the Red and Black cords (B) and
the siren to the Grey cords (C).
If the red led lights up
invert the BUS polarity.
Before working on the
siren, put the system
into maintenance mode.
C
High voltage present near
Red led
the flasher lamp.
3
84424
5 mA
8 mA
48 - 54 mA
Two wire
6.5 - 7.2 Ah
15 min.
105 dB(A) at 3 m.
1500 Hz
30 - 60
2.5 kg
IP34
-25 - +55 °C
F1: F5AL
A - Power supply pair (WHITE)
B - Battery
Positive battery (RED)
Negative battery (BLACK)
C - Loudspeaker (GREY)
C
Red led
1
2
Connections of the electronic card
cords
Colour Connection
White
Telephone pair (BUS)
White
Telephone pair (BUS)
Red
+ Battery positive
Black
- Battery negative
Grey
Acoustic signaller
Grey
Acoustic signaller
683157
400 - 450 mA
12 Ah
3
4
3