Important notes
Knee orthosis
Dear user,
We are pleased that you have chosen a
product from Ofa Bamberg and would like
to thank you for putting your trust in us.
Please take a moment to read through this
product information carefully to ensure
optimum effectiveness of your Dynamics
product.
Ofa Bamberg wishes you a speedy
recovery!
←
Fitting instructions
The fi tting instructions in pictures can be found on the fold-over
page at the beginning of the brochure.
1
To put on the knee orthosis, open the Velcro tapes at the rubberised end
and pull them out of the eyelet. When putting the orthosis on, please
note that it becomes narrower at the lower end. Put the orthosis against
the front of your leg with the leg slightly bent. It is sitting correctly if
the middle of the joint is positioned at the level of the lower edge of the
kneecap.
2
Please note that the Velcro tapes must be fastened in the correct order.
First fasten the top tape at the lower leg by pulling it through the
corresponding eyelet and fastening it down. Then fasten the bottom tape
at the thigh, then the top one. Then fasten the lower tape at the lower
leg. Please ensure that to prevent pinching the product is secure but not
too tight.
The Dynamics knee orthosis made from
lightweight, robust carbon material stabil-
ises the knee after injuries or operations. It
provides the joint with a defi ned range of
motion that can be individually adjusted.
The four-axis joint provides optimum simu-
lation of natural knee movement.
Please note
– The initial adjustment and strap-
ping on of the product must be
carried out by qualified specialist
staff.
– If the product has to be worn in
combination with other products,
then please discuss this in
advance with your doctor.
– If you experience an unpleasant
sensation, intense pain or any
other problem when wearing
the product, then contact your
doctor or specialist supplier
immediately.
– We use a comprehensive
quality management system to
check our products. However,
should there still be reason for
complaint, please contact your
specialist supplier.
→
see page 6