Uline H-8280 Manual Del Usuario página 2

4. With two additional people, turn tabletop panel
upside down. Install 12 camlock pins (A).
(See Figure 2)
Figure 2
A
5. With two additional people, turn tabletop panel
upright and gently lower onto leg panels and
modesty panels. Ensure camlock pins (A) and
dowels (C) fit into corresponding holes. (See Figure 3)
6. Cover each camlock (B) with a camlock sticker (D).
(See Figure 3)
Figure 3
7. Stick adhesive-backed cable clips under tabletop
panel to secure and route cables.
PAGE 2 OF 6
ASSEMBLY CONTINUED
Tabletop Panel
C
D
1-800-295-5510
uline.com
POWER CENTER INSTALLATION
1. Remove the screw on each end of power center
and lift silver cover to open and expose four screw
holes. (See Figure 4)
2. Insert opened power center into hole in middle of
add-on top. (See Figure 5)
Figure 4
3. Use four screws included with power center to attach
power center to table. (See Figure 6)
Figure 6
NOTE: Screws above are included with power
center.
4. Replace silver cover and attach using two screws.
(See Figure 7)
NOTE: Use cable clips to organize wires under
the table. (See Figure 7)
Figure 7
Figure 5
Cable Clip
0821 IH-8280