Lloyd's LC-1330 Guía Rápida De Instalación página 16

• Flashing blue light: the video doorbell is in setup mode.
• Red light on: there is a failure in the connection to the Wi Fi
signal.
• Blue light on: the device is connected to the Wi Fi network.
8. PIR (infrared sensor): detects movement in front of the device
to trigger notifications.
9. Reset button: to reset the device, press and hold this button
for 5 seconds.
10. Battery compartment: operates with 2 rechargeable
batteries type 18650 (included).
ATTENTION:
Danger of explosion if the batteries are not replaced
correctly. Batteries installed in this device must not be
exposed to excessive heat such as sunlight, fire or the like.
Dispose of batteries in specified collection sites, do not
throw them in the garbage.
11. USB port: for recharging batteries via USB cable.
12. Holes for mounting bracket attachment.
13. Memory card slot (not included). To locate it, the battery
compartment cover must be removed.
Wall mount
Mark the holes on the wall where the video doorbell is to be
placed, using the slots on the mounting bracket as a guide,
then drill over the marks and insert the anchors.
Attach the mounting bracket using the screws, then place the
video doorbell on the bracket by carefully sliding it from the
top. Secure it to the bracket by fastening the bottom part with
two screws.
WARNING:
this unit must be securely anchored to the floor/wall according
to the installation instructions to avoid any damage
16