Electrolux EHF3320NOK Manual De Instrucciones página 15

Placa de cocción
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
comes on.
comes on.
and a number come on. There is an error in the
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
Possible cause
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Automatic Switch Off oper‐
ates.
Child Safety Device or
Lock operates.
hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use".
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If
comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Remove the
fuse, wait one minute, and
insert the fuse again.
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido