Overload Protection - Genesis GLSD08B Manual Del Operario

OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY PACK
(FIG 2)
• To install the battery pack, insert the battery pack (8) from the bottom of the
tool all the way until it locks in place with a click, as shown in fIG 2.
• To remove the battery pack, slide the battery locking tab (7) to the left as
shown in fIG 2, to release the battery pack, then pull the battery pack out.
CHARGING THE BATTERY (FIG 3)
NOTE:
Always Check that the power supply corresponds to the voltage on
the ratings plate.
• Connect the charging adaptor (9) and the charging stand (10).
• Plug the adaptor into a 120 Volt AC power source. The GReeN light on the
charging stand will illuminate, indicating the charger is powered.
• Insert the battery (8) all the way into the charging stand until it locks in place
with a click, as shown in fIG 3. The ReD light on the stand indicates that the
battery is charging.
• The light will turn GReeN after charging is complete.
• To remove the battery from the stand, depress the locking tab on the stand
to release the battery pack. See fIG 3.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a completely discharged battery.
TRIGGER SWITCH ACTION
• Turn the screwdriver on by depressing the trigger switch (5-fIG1).
• use the forward/reverse switch (6-fIG1) to change the direction of rotation of the driver.
• The forward/reverse switch has three positions: forward, Reverse, and Off (middle).
• Always check the rotation before beginning your work.
TWO-SPEED GEAR SWITCH
• Slide the speed gear switch (3-fIG 1) to choose between position 1 for low speed 200 RPM and position 2 for
high speed range 400 RPM.
• The low speed has more power and torque. use the low speed for high power and torque applications.
• The high speed is for fast drilling or driving applications.

OVERLOAD PROTECTION

Your tool is equipped with an overload protection circuit to protect the motor and battery in the event of a stall.
When the tool is stalled, it will automatically turn itself off. If this happens, remove the tool from the work piece,
turn off the tool, wait for a few seconds, then turn it on and continue using it. Sometimes, when the battery is low,
the tool may shut down automatically more often. This indicates it is time to recharge the battery.
LED WORK LIGHT
Your tool has a built-in LeD work light (4-fIG 1) to illuminate the work area. When you turn on the tool, the work
light will automatically turn on.
8
All manuals and user guides at all-guides.com
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
8V Lithium-ion Screwdriver
Operator's Manual
8
FIG 2
8
LOCKING TAB
10
GLSD08B
7
9
FIG 3