Maintenance; General Information; Clean The Machine; Replace The Spool - GreenWorks STG304 Manual Del Operador

EN
• Move the machine from right to left to prevent thrown
debris from hitting the operator.
• Do not cut in the danger area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
10.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
10.3

REPLACE THE SPOOL

1. Push the tabs （20） on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover （19）.
3. Remove the spool (21).
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on the
new spool, and is extended approximately 5 in. before you
install the new spool.
5. Put the end of the cutting line through the eyelet (23).
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing (22).
8. Push the spool cover until it clicks into position.
10.4

REPLACE THE CUTTING LINE

Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
10
NOTE
NOTE
NOTE