SBM HANDER HRH-500 Instrucciones De Servicio página 2

5.1
1
2
5.2
1
2
6
2
1
2
1
7 10
8
9
Never use tool when cord is damaged; have it replaced
English
by a qualiÞ ed person
Always check that the supply voltage is the same as
the voltage indicated on the nameplate of the tool (tools
Rotary hammer
with a rating of 230V or 240V can also be connected to a
220V supply)
INTENDED USE
If the drill bit becomes unexpectedly jammed (causing
This tool is intended for hammer drilling in concrete, brick
a sudden, dangerous reaction), immediately switch off the
and stone; for drilling in wood, metal and plastic as well as
tool
for screwdriving (speciÞ c accessories should be used) Be aware of the forces that occur as a result of jamming
The hammering system in this tool outperforms any tradi- (especially when drilling metals); always hold the tool
tional ratcheting drill when drilling in concrete
Þ rmly with both hands and take a secure stance
This tool is designed for use in combination with all stand-
Always disconnect plug from power source before mak-
ard SDS+ accessories ing any adjustment or changing any accessory
Holding the tool
- keep the ventilation slots uncovered
1
TECHNICAL SPECIFICATIONS - do not apply too much pressure on the tool; let the tool
do the work for you
PRODUCT ELEMENTS 2
Your machine is double insulated in accord-
ance with EN 50144; therefore no earthwire
1 On/Off switch
is required
2 Switch locking button
3 Switch for selecting operating mode
MAINTENANCE
4 Locking sleeve
5 Auxiliary handle
Make sure that the machine is not live when
SAFETY
carrying out maintenance work on the motor.
WARNING! Read all instructions. Failure to follow all in-
structions listed below may result in electric shock, Þ re
Regularly clean the machine housing with a soft cloth,
and/or serious injury.
preferably after each use. Keep the ventilation slots free
Wear ear protectors with hammer drills (exposure to from dust and dirt.If the dirt does not come off use a soft
cloth moistened with soapy water. Never use solvents
noise can cause hearing loss)
such as petrol, alcohol, ammonia water, etc. These sol-
Use auxiliary handles supplied with the tool (loss of con-
trol can cause personal injury) vents may damage the plastic parts.
Avoid damage that can be caused by screws, nails and Every six months it is recommended to take your machine
to Service Center to change the grease.
other elements in your workpiece; remove them before
you start working Should a fault occur, e.g. after wear of a part, please con-
Always keep the cord away from moving parts of the tact your local SBM Group dealer.
tool
When you put away the tool, switch off the motor and ENVIRONMENT
ensure that all moving parts have come to a complete In order to prevent the machine from damage during
standstill transport, it is delivered in a sturdy packaging. Most of the
Use completely unrolled and safe extension cords with packaging materials can be recycled. Take these materi-
a capacity of 16 Amps (UK 13 Amps) als to the appropriate recycling locations. Take your un-
In case of electrical or mechanical malfunction, immedi- wanted machines to your local SBM Group dealer. Here
ately switch off the tool and disconnect the plug they will be disposed of in an environmentally safe way.
SBM Group can assure ß awless functioning of the tool
only when original accessories are used
Use only accessories with an allowable speed matching
at least the highest no-load speed of the tool
This tool should not be used by people under the age
of 16 years
Be careful not to drill or drive into areas where electrical
wires may be contacted
If the cord is damaged or cut through while working, do
not touch the cord, but immediately disconnect the plug
6