Removing Collected Water; Important; Water Level; Bucket Operation - GE AWHR50 Manual Del Propietário

Using the Dehumidifier
Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed, the unit
will shut off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket
to collect water. When the hose is connected, water will
flow through it onto the floor instead of into the bucket.
NOTES:
• Do not remove the bucket while the dehumidifier is
operating or if it has just stopped operating. This might
cause some water to drip from the drain pan.
• The bucket must be in place and securely seated for
the dehumidifier to operate.

Water Level

The dehumidifier will turn off automatically when the
bucket is full, or when the bucket is removed or not
replaced in the proper position.

Bucket Operation

DO NOT remove the foam piece and magnet block in the
bucket assembly.
If removed the Dehumidifier will not work properly.
49- 5000629 Rev. 0
Use a hose. Water can be automatically emptied into
a floor drain by attaching a garden water hose (not
included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
3. Thread a garden hose (not supplied) onto the nozzle
and ensure it is seated securely. Cut to length and
lead it to the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely seated
for the dehumidifier to operate. The drain hose must run
down from the dehumidifier to the floor drain.
The bucket must be replaced in the proper position for
the dehumidifier to work. The empty indiator will blink
and the dehumidifier will not run if the bucket is not in the
proper position.
7