Know Your Product; Operation - SPARKY PROFESSIONAL K 3260 Instrucciones De Uso Originales

ity with easily flammable liquids and gases. The work-
ing place should be well lit.

Know your product

2. Tool retainer
4. Side handle
5. Body
6. Ventilation slots
10. Handle
11. Supply cord with plug
12. Grease tank cover
13. Grease tank

Operation

This power tool is supplied from single-phase alternat-
ing current mains only. It is double insulated according
grounded sockets. This power tool is radio suppressed in
compliance with EMC Directive 2004/108/EC.
This power tool is designed for chiselling, chipping and
demolishing concrete, rocks and asphalt with high effi-
ciency.
power tool must be connected to the power supply
plug is connected to a receptacle while the power
operating immediately, which could cause a serious
accident.
replacement of the supply cord is necessary, this has
to be done by the manufacturer or his agent in order
to avoid a safety hazard.
cedure on the power tool or in case of mains drop
out.
use as short as practicable extension cord with prop-
er cross-section.
and securely fastened.
WARNING: Switch off and unplug the ma-
chine prior to any procedure on the power tool.
1. Clean and then smear the tool shank with grease or
machine oil (Fig. 1).
6
EN
-
ing it at 180° in the opposite direction (Fig. 2).
To remove the bit, follow the above described proce-
dures in reverse order.
WARNING: Before plugging in the tool, al-
Insert the plug into the socket.
Apply the tool tip at 80–100 mm from the edge of the
material to be processed and press the trigger switch
Start operating at 70°–80° to the surface and guide
and break the processed material.
Operate the machine by utilizing its empty weight to
achieve optimum performance. Insufficient force shall
cause tool rebound. Too high pressure against the
surface shall decrease efficiency.
In some cases, it is necessary to punch the tool tip
against the crushing position forcibly in order to actuate
the striking motion. This is not due to malfunction of the
tool. It means that the safeguard mechanism against no-
load striking is working.
WARNING: Sometimes the striking motion
does not start even when the motor rotates because
the grease has become thick. If the demolition ham-
mer is operated at low ambient temperature or after
-
to warm up.
Turn the tool at regular intervals to achieve uniform
wear and aid self-sharpening.
This power tool is supplied with the following accesso-
struction manual for PK 20/32.
-
(Fig. 3)
-
K 3260