How To Stop Your Pressure Washer; How To Use Accessory Tray - Sears CRAFTSMAN 580.752880 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for two
minutes.
2. Push engine rocker switch to off position (O or OFF).
3. ALWAYS point spray gun in a safe direction, push red
button and squeeze spray gun trigger to release retained
high water pressure.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure, every
time you stop engine.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension. There is also a
detachable hose wrap at the front of the accessory tray to
hold your high pressure hose.
1. Place nozzle extension in groove on accessory tray as
shown. Pull rubber strap tight around nozzle extension
and place hole in strap over tab on accessory tray.
2. Place spray gun in groove on accessory tray as shown.
Pull rubber strap tight around spray gun and place hole in
strap over tab on accessory tray.
3. Wrap high pressure hose on hose wrap then attach hose
wrap to front of accessory tray.
4. Place selector nozzle in hole on Quick Switch™ assembly
tray.
2700 PSI
2.1 GPM
2300 PSI
2050 PSI
2.2 GPM
2.3 GPM
How to Use Selector Nozzle
The selector nozzle allows you to switch between five
different spray pattern nozzles. Spray patterns can be
changed while pressure washer is running once spray gun
trigger safety lock is engaged. The spray patterns vary as
shown below.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER change spray patterns without the trigger locked on the
spray gun.
• DO NOT twist selector nozzle while spraying.
Follow these instructions to change nozzle patterns:
1. Select desired spray pattern:
MAX - For stubborn or hard to reach surface such
as second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.).
GENERAL - For most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc..
DELICATE - For gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment, etc..
FLUSH - For quick high flow clean up and long
reach cleaning of second story siding and windows.
SOAP - For general soap applications or to launch
soap to second story siding and windows.
2. Push button on selector nozzle, nozzle dial will pop up.
3. Turn dial until desired spray pattern lines up with button
on selector nozzle.
4. Push dial in until it locks into place.
Usage Tips
For most effective cleaning, keep selector nozzle from
8 to 24 inches (20 to 61 cm) away from cleaning surface.
If you get selector nozzle too close, especially using a
high pressure spray pattern nozzle, you may damage
surface being cleaned.
DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
14

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido