Mode Selector; Rotation Direction - Motorhead MH-03-HD-B1-0-1 Manual De Instrucciones

20V ULTRA Hammer Drill 2Ah KIT (MH-03-HD-B1-0-1)
- Inserting and removing the battery
• Always have drill rotation switch in neutral/lock position when removing or inserting
battery to avoid unintentional starting.
• To insert, simply push pack in until lock spring clicks.
• To remove battery pack from the tool, press the lock spring buttons (d in the functional
description) and pull out.
SWITCH (E in the functional description)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
- Switch lock
• The switch trigger can be locked in
the center position.
• This helps to reduce the possibility of
accidental starting when not in use. To
lock the switch trigger, place the
direction of rotation selector in the
center position.

- Rotation direction

• Direction of rotation is controlled by
the direction of rotation selector
located above the switch trigger.
• Right: To select forward rotation,
forward/reverse lever to the left side of
the tool.
• Left: To select reverse rotation, push
the lever to the right side of the tool.
- Variable speed
• This tool has a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
• Speed is controlled by the amount of switch trigger depression.
14
20V ULTRA Hammer Drill 2Ah KIT (MH-03-HD-B1-0-1)
Torque Regulator
• This is a 16+1+1 position ring (B in the functional description) situated between the chuck
and the drill body.
• When arrow on the top of the housing points to 1 on the Torque indicator scale, torque is
at minimum before the clutch disengages the chuck from the drive.
• When indicator is just past 16, output is at maximum before it is disengaged. This is
• More torque will set a screw deeper into material, less torque will prevent it stripping.
Larger screws require more torque to drive than small ones. A little trial and error will
show you which is the optimum setting for the situation.
• Release the trigger when the clicking sound indicates the chuck will not turn further.
• For drilling, always use the drill setting, indicated by the pictogram of a drill bit at this
setting, the drive does not disengage from the chuck.

Mode Selector

• Turn the torque adjustment ring and let the pointer align to the impact mode
selects the impact mode of action.
• Turn the torque adjustment ring and let the pointer align to the drill mode
the drill mode of action.
Screw Driving
15
that
that selects