Nice Oview Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

8
Timed command
00 04:02 |mmgvsd
01 04:02 |mmgvsd
02 04:02 |mmgvsd
03 04:02 |mmgvsd
Back Select
• Programming the control unit and receiver
To program the parameters of a device, proceed as follows:
WARNING – Access to the functions under the heading "automa-
tions" may require entry of a password, if the installer has decided
to restrict access to the programming functions. For further infor-
mation refer to the paragraph "Working with passwords".
a) select the series to which the device to be programmed belongs;
b) in the home page (fig. 7) select "menu" by means of key G (8 – fig. 6) and
then select "automations": the window displays the list of devices connected
and present in this series.
c) This window enables the user to:
– scroll through the list of names of devices present, using the arrow keys
or ;
– access the next series by using arrow key
of arrow key ;
– confirm selection of a device, by means of key 6 or 8;
d) On confirmation of the selection, a window is displayed, showing the "func-
tions menu".
This menu normally comprises the following items:
– "common functions" (containing the functions present on all control units
and receivers);
All manuals and user guides at all-guides.com
Important – Ensure that the
clock is set precisely at the local
time.
Caution – The timed com-
off
mands are only enabled if the
off
"timed command activation" is
off
activated (under the heading
off
"settings").
or the previous series by means
– "control unit functions" (functions specific to the control unit);
– "radio functions" (functions specific to the receiver);
– "advanced functions" (special functions present on all control units and
receivers);
– (etc......)
Note – The presence or absence of some of the items in the "functions menu"
depends on the type of device selected.
––– VERY IMPORTANT –––
Each item in the functions menu enables access to a series of
functions that enable the configuration and personalisation of
operation of the selected device.
The complete lists of these functions, related to each control unit
or receiver, are found on the CD "Programmable functions of de -
vices with BusT4 connectors" supplied in the pack.
• Setting the Oview operating parameters
• To set the Oview operating parameters, enter the home page (fig. 6), and
select "menu" by means of the key G (8 - fig. 6) and then select "settings".
The window displays the list of parameters available: "name" - "date/time" -
"timed command activation" - "display brightness"- "key brightness" -
"installer password" - "user password" - "information" - "language" - "net-
work options" - "communication".
To display and modify individual parameters, select and proceed in the window
displayed.
– name: used to assign a personal name to Oview, for easy identification in a
device network;
– date/time: used to set the local date and time. The arrow keys
and 4 – fig. 6) enable the user to move between fields for the date and time
and keys and (3 and 5 – fig. 6) enable modification of the relative val-
ues;
– timed command activation used to activate or deactivate the timed com-
mands. ON / OFF type command; the factory setting is "ON";
– display brightness: used to adjust the display brightness. This can be set
with a value from minimum 0% to maximum 100%. Note – After 30 seconds
of inactivity, the display brightness is reduced to the minimum set value;
– key brightness: used to adjust the key brightness. This can be set with a
and (2
English – 8