Assembly; Lights; Cleaning And Storing; Troubleshooting - MELINERA 972-B Instrucciones De Uso Y De Seguridad

with limited physical, sensory or mental
abilities or lacking in experience and
knowledge, if they are supervised or have
been instructed as to the safe use of the
product and understand the resulting
hazards. Do not let children play with the
product. Cleaning and maintenance may
not be carried out by children without
proper supervision.
Do not use the product if you notice any
„
defects.
The row of lights must not be connected to
„
the mains power supply while still in the
packaging.
Once the light has reached the end of its
„
service life, it must be disposed of in
accordance with local disposal regulations.
The LEDs are non-replaceable.
The light must not be used without the
„
sealing ring properly fitted to the cable
7
(see Fig. B)!
If using the product outdoors, you should
„
only ever connect the mains adaptor
an IP44-rated socket (see Fig. B).
RISK OF INJURY! When removing the
„
light, make sure that you also remove the
ground spike so as to avoid any risk of
2
injury (e.g. trip hazard) (see Fig. A).
TRIP HAZARD! Please make sure that the
„
power cable is routed in such a way
3
that nobody can tread on it or trip over it
(see Fig. A).
z Assembly
Please note: Dispose of all packaging
material�
Please note: Only use the mains adaptor
supplied with the product (see Fig. B).
4
Fit the LED strip light
„
ground spike (see Fig. A).
2
Now connect the power cable
„
mains adaptor
4
sleeve nut tightly onto the mains
8
adaptor (see Figs. A and B).
4
4
together with the
1
to the
3
and then screw the
RISK OF INJURY! When removing the
light, make sure that you also remove the
ground spike
injury (e.g. trip hazard) (see Fig. A).
z Operating the LED strip

lights

Plug the mains adaptor supplied into an
„
IP44-rated socket designed for the purpose.
The article will light up in permanently on
mode.
To activate the timer function, press the
„
button marked "PRESS"
then light up green.
To switch off the article, press the button
„
marked "PRESS"
z Cleaning and storing
Switch off the product by pressing the
„
button marked "PRESS"
to stop using it, clean it and store it away
(see Fig. B).
Regularly inspect the LED strip lights for dirt
„
and contamination. Remove any dirt to
ensure the product works correctly.
Clean the product with a clean, damp cloth
„
and a mild detergent.
z Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on.
= The product is switched off.
= Press the PRESS switch
switch the product on (see Fig. B).
so as to avoid any risk of
2
. The button will
5
again.
5
if you wish to
5
5
GB/IE/NI/CY/MT
to
31