Handset
4.3 Changing menu cards
The menu card changing process may only be carried out in a dry and
clean environment.
Switch the Orderman Max2 off and carefully loosen both screws on the
underside of the device (see figure page 13).
You can now remove the locking part and then remove the menu card
from the Orderman Max2.
Push the new menu card straight until it fits into the handset. Then screw
the locking part carefully back on with the two screws. After switching on
the device and identification of the menu card, operation can recom-
mence.
Carry out touch calibration (see page 16) after each menu card change.
For optimal legibility only use menu card transparencies that
have been specifically designed for the device. Do not use pa-
per or other materials, because possible residue in the device is
Note
difficult to clean.
5
Declarations of conformity
Page 42
Max2
- 17 -
User Manual