senya SYCP-IM002 Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
9. After finish, turn off and unplug the machine, then move it to a sink, unplug the Drain Stopper
to empty the water tank.
IV- ADVICE CARE AND STORAGE
1. Unplug the machine before cleaning.Clean the water tank, basket and shovel frequently.
2. Do not use mechanical devices or other means to accelerate the defrosting process,other than
those recommended by the manufacturer.
3. Clean regularly surfaces that can come in contact with food and accessible drainage systems.
4. Clean water tanks if they have not been used for 48 h; flush the water system connected to a
water supply if water has not been drawn for 5 days.
5. If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and
leave the door open to prevent mould developing within the appliance.
V- TROUBLESHOOTING GUIDE
If the power is suddenly cut off during the making ice process, the ice on the evaporator cannot
fall off automatically and accumulate on the water box. At this time, unplug the power cord and
gently push the automatic shovel to the original position by hand, then take out the ice.
PROBLEM
The machine is not
work abnormally with
a buzzing noise
Add water indicator
flash red
The Ices are stick
together
The machine works
normally, but no ice is
produced
All indicators flash
simultaneously
When the ice is full, Ice
full indicator is not
flash
POSSIBLE CAUSE
The voltage is lower than
recommended
1.No water in the tank
2.The pump is full the air
Ice remain in the water
box or evaporator
The compressor has no
refrigerant
The water box is blocked
by ice.
The sensors is interfered
by sunlight
SUGGESTED SOLUTIONS
Turn off Ice maker and do not restart until
the voltage is normal
1.Fill 500ml-1500ml of water.
2.Press On/Off button to restart,try again
Turn off the machine and remove the ice
Contact the local professional organization
to fill with R600a refrigerant
Unplug the power to take out the ice, then
plug in power again, and press the button.
After 3 minutes, the machine will restart
automatically.
Prevent the sensors from interfered by
sunlight
16

Publicidad

Tabla de contenido
loading

Tabla de contenido