Device Delivery And Storage; Delivery; Device Identification; Damage During Transport - Gewiss JOINON EASY GW68122 Manual De Uso E Instalación

JOINON EASY electric vehicle recharging unit
4.
28

DEVICE DELIVERY AND STORAGE

4.1. DELIVERY

Keep the device packaged until installation.

4.2. DEVICE IDENTIFICATION

The serial number of the device identifies it in an unequivocal manner. In any communication with Gewiss, refer-
ence must be made to this number.
The device serial number is indicated on the label inside the door above the one-way switches.

4.3. DAMAGE DURING TRANSPORT

If the device was damaged during transport:
1. Do not install it.
2. Notify the fact immediately (within 5 days of delivery).
If it is necessary to return the device to the manufacturer, the original packaging must be used.

4.4. STORAGE

Failure to observe the instructions provided in this section could cause damage to the device. The manufac-
turer declines all responsibility for damage deriving from the failure to observe these instructions.
If the device is not installed immediately upon delivery, to avoid its deterioration, proceed as indicated below:
• To correctly conserve the charging station, do not remove the original packaging until the moment it is installed.
• Deterioration of the packaging (cuts, holes, etc.) prevents the correct conservation of the charging station prior
to installation. The manufacturer declines all responsibility relative to the consequences caused by packaging
deterioration.
• Keep the device clean (remove dust, chips, grease, etc.) and avoid the presence of rodents.
• Protect it against water spray, welding sparks, etc.
• Cover the device with a protective breathable material to avoid condensation caused by environmental humidity.
• Charging stations kept in a warehouse must not be subjected to climatic conditions other than those indicated
below:
Environmental conditions
Minimum temperature
Minimum temperature of the surrounding air
Maximum temperature of the surrounding air
Maximum relative humidity without condensation
• It is very important to protect the system against corrosive chemical products and saline environments.
-20°C
-20°C
70°C
95%