Beta 1949GPA Manual De Uso E Instrucciones página 5

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING TYRE INFLATOR
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR EYE PROTECTION WHILE OPERATING PNEUMATIC TOOL OR
PERFORMING MAINTENANCE JOBS
PRODUCT SPECIFICATIONS
MEASURING RANGE
RESOLUTION
MAX. OPERATING PRESSURE
AIR HOSE LENGTH
THREADED FITTING
INSTRUCTIONS
Air supply connection
For optimal use of the tyre inflator, always keep to a maximum pressure of 15 bar, as measured at the tool inlet. Feed the tool
with clean, condensate-free air. Excessively high pressure or humidity in supply air may damage the tool.
USE
Fit the inflator connector onto the valve of the tyre to check.
Tyre pressure adjustment
- To deflate, gently press the lever to approximately half stroke. Release the lever to display tyre pressure.
- To inflate, press the lever to stroke end. Release the lever to display tyre pressure.
MAINTENANCE
Repair and calibration must be carried out by trained personnel only. For this operations, you can contact Beta Utensili S.P.A.'s
repair centre.
DISPOSAL
The inflator, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country. disposal of hazardous waste and will give way to the application of such fines as provided for under current regulations
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty
for professional use or a 24-month warranty for nonprofessional use. We will repair any breakdowns caused by material or
manufacturing defects by fixing the defective pieces or replacing them at our discretion. Should assistance be required once or
several times during the warranty period, the expiry date of this warranty will remain unchanged. This warranty will not cover
defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no longer be valid if any
changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces. This warranty explicitly excludes
any damage to people and/or things, whether direct or consequential.
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
0 ÷ 12 bar (0-180 PSI;0- 1200KPa;0- 12,23KGF)
0.1 bar (14,50 PSI; 100KPa; 1,019KGF)
12 bar (180 PSI; 1200KPa; 12,23KGF)
450 mm
1/4" GAS
EN I
5